蒸發器雖然很好用，但是在使用過程中先后出現蒸發器融霜電加熱管燒壞，集水盤加熱室燒壞的現象，因此給大家介紹一下蒸發器設備存在的問題，分析了產生問題的根源，并提出相應的改進措施。
Although the evaporator is very useful, the phenomenon that the electric heating tube of the defrosting evaporator is burned out and the heating chamber of the water collecting plate is burned out appears successively in the course of using. So this paper introduces the existing problems of the evaporator equipment, analyzes the causes of the problems, and puts forward the corresponding improvement measures.
蒸發器經常融霜失敗
Evaporator often defrost failure.
蒸發器電加熱管非常容易燒壞，而且由于蒸發器電加熱管是由兩根加熱管串聯一組，其中一個燒壞，線路中斷就不能正常工作，因此蒸發器本體上的霜就不能融化。
The evaporator electric heating pipe is very easy to burn out, and because the evaporator electric heating pipe is composed of two heating pipes in series, one of which burns out, the circuit interruption can not work properly, so the frost on the evaporator body can not melt.
集水盤結冰
Ice on water collecting tray
集水盤內部沒有設置電加熱管，雖然設有與落水管內相同的電加熱絲,但功率很小，質量較差,經常發生故障，由于低溫度溫度抵達-18℃以下，當蒸發器融霜后，進入集水盤的水還來不及泄放就會重新結冰，不能正常通過落水管流走。
There is no electric heating pipe in the water collecting pan, although the same electric heating wire is installed in the water collecting pan, but the power is very small, the quality is poor, and often failures occur. As the low temperature temperature temperature reaches below - 18, when the evaporator defrosts, the water into the water collecting pan will re-freeze before it has time to discharge, and it can not normally flow through the water collecting pan. Go.
落水管冰堵
Water plugging of downpipe
落水管電加熱絲故障。由于落水管電加熱絲始終處于工作狀態，加上本身質量較差，所以落水管電加熱絲故障率很高。由于原來落水管較長，其電加熱絲一旦故障，在低溫環境下，進入落水管的水還沒等流走就又開始結冰了，始終無法正常實現融霜。
The breakdown of the electric heating wire of the water pipe. Because the electric heating wire of the falling water pipe is always in working state and its quality is poor, the failure rate of the electric heating wire of the falling water pipe is very high. Due to the long drop pipe, once the electric heating wire breaks down, the water into the drop pipe begins to freeze again before it has flowed away in the low temperature environment, and the defrosting can not be realized normally.
改進措施：
Improvement measures:
1、蒸發器無法融霜的主要原因是因?yàn)殡娂訜豳|(zhì)量攢在問題造成的，并且使用的是串聯方式。因此我們應該使用額定電壓為220v的加熱管，并且使用并聯的方式。
1. The main reason why the evaporator can't defrost is that the electric heating quality is accumulated in the problem, and the series connection is used. Therefore, we should use heating pipes rated at 220V, and use parallel connection.
2、重新定制集水盤，保證蒸發器融霜的水到集水盤后不會二次結冰。
2, redesign the water collecting tray to ensure that the evaporator defrosting water will not freeze for two times after the water collecting tray.
3、改進截短落水管，是落水管盡可能的短，在集水盤下再加一個集水桶，在集水桶內的水未滿之前，更換新的集水桶。
3. Improving the truncated downcomer is to shorten the downcomer as short as possible, add a catchment bucket under the catchment pan, and replace the new catchment bucket before the water in the catchment bucket is full.
